Circle command in autocad

To create an arc, you can specify combinations of center, endpoint, start point, radius, angle, chord length, and direction values. Arcs are drawn in a counterclockwise direction by default.

Hold down the Ctrl key as you drag to draw in a clockwise direction.

Start point

Draws an arc using three specified points on the arc's circumference. The first point is the start point (1).

Note: If you press ENTER without specifying a point, the endpoint of the last drawn line or arc is used and you are immediately prompted to specify the endpoint of the new arc.

This creates an arc tangent to the last drawn line, arc, or polyline.

Fillet command in autocad

Second point

Specify the second point (2) is a point on the circumference of the arc.

End point

Specify the final point (3) on the arc.

You can specify a three-point arc either clockwise or counterclockwise.

Center

Starts by specifying the center of the circle of which the arc is a part.

Start point

Specify the start point of the arc.

End poi